Installing the display panel
1 Place the display panel on a plane surface.
2 Connect the display cable to the connector on the system boar
NOTE
: Make sure to insert the cable under the clips, if not, the system may not display video after reassembling.
3 Place the metal bracket and replace the M1.6x2.5 (2) screws to secure the display panel.
4 Connect the battery cable to the connector on the system board.
5 Place the metal bracket and replace the M1.6x2.5 (1) screw that secures the connector on the system board.
6 Install the display panel on the tablet and press the edges until they snap-in.
7 Replace the M2x4 (4) screws to secure the tablet to the display panel.
8 Install microSIM card and microSD card.
9 Follow the procedure in After working inside your tablet.
Battery
Removing the battery
1 Follow the procedure in Before working inside your tablet.
2 Remove the:
a microSIM card and microSD card
b display panel
3 To remove the battery:
a Remove the M2x3 (4) screws that secure the battery to the tablet [1].
b Lift the battery from the tablet [2].
Removing and Installing components
23
To Next Page
Loading...
