Installing the thunderbolt over Type-C USB bracket
1 Insert the thunderbolt over Type-C USB bracket into the slot on the tablet.
2 Replace the M2x2.0 (3) screws to secure the thunderbolt over Type-C USB bracket to the tablet.
3 Install the:
a battery
b display panel
c microSIM card and microSD card
4 Follow the procedure in After working inside your tablet.
System Board
Removing the system board
NOTE: Heat sink is not a separate service part but is included with the system board. Do not remove the heat sink from the
system board
1 Follow the procedure in Before working inside your tablet.
2 Remove the:
a microSIM card and microSD card
b display panel
c battery
d WLAN card
e SSD card
f WWAN card
g front camera
h rear camera
i coin cell battery
j thunderbolt over Type-C USB bracket
3 Disconnect the following cables from the system board:
a power button cable [1]
b USH board cable [2]
c audio board cable [3]
d docking board cable [4]
e USH board cable [5]
Removing and Installing components
37
To Next Page
Loading...
