a Remove the M2x2.0 (1) screw securing the WLAN bracket [1].
b Lift the WLAN bracket away from the system board [2].
c Disconnect the antenna cables from the WLAN card [3].
d Slide and lift the WLAN card from the connector on the system board 4].
Installing the WLAN card
1 Insert the WLAN card into the connector on the system board.
2 Connect the antenna cables to the WLAN card.
3 Insert the WLAN bracket to the WLAN card.
4 Replace the M2x2.0 (1) screw to secure the WLAN bracket.
5 Install the:
a battery
b display panel
c microSIM card and microSD card
6 Follow the procedure in After working inside your tablet.
PCIe Solid State Drive (SSD)
Removing the SSD module
1 Follow the procedure in Before working inside your tablet.
2 Remove the:
a microSIM card and microSD card
26
Removing and Installing components
To Next Page
Loading...
