NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage
b Remove the M2.0 x 3.0 screw to release the metal bracket on the power connector port [2].
c Lift the metal bracket from the system [3].
d Remove the power connector port from the computer [4].
Installing power connector port
1 Install the power connector port into the slot on the system.
2 Place the metal bracket on the power connector port.
3 Replace the M2.0 x 3.0 screw to secure the power connector port to the system.
4 Connect the power connector port cable to the connector on the system board.
5 Install the following:
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Display Assembly
Removing display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
24
Removing and installing components
To Next Page
Loading...
