Installing display assembly
1 Place the base of the computer on a plane surface of a table and position it closer to the edge of the table.
2 Install the display assembly to align it with the display hinge holders on the system.
3 Holding the display assembly, replace the six (M2.5 x 4.0) screws to secure the display hinges on the system display assembly with the
system unit.
4 Route the eDP cable from the routing channel.
5 Ax the tapes to secure the eDP cable (display cable) to the system board.
6 Connect the eDP cable to the connector on the system board.
7 Install the eDP metal bracket on the eDP cable and tighten the M2.0 x 3.0 screws.
8 Route the WLAN and WWAN cables through the routing channels.
9 Install the:
a WLAN card
b WWAN card
c battery
d base cover
10 Follow the procedure in After working inside your computer.
Display Bezel
Removing display bezel
NOTE
: The display bezel removal procedure is applicable only for non-touch systems.
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
26
Removing and installing components
To Next Page
Loading...
