Dell Latitude 7290 - Installing the Display Panel

Installing the display panel
1 Connect the display cable on the back of the display panel.
2 Ax the mylar tape securing the display cable on the back of the display panel.
3 Ax display connector adhesive strip to the display panel.
4 Flip the display panel over and slide the display panel towards the system.
5 Replace the two (M2.0 x 3.0) screws on the panel
6 Install the:
a display assembly
b WLAN card
c WWAN card
d battery
e base cover
7 Follow the procedure in After working inside your computer.
Camera
Removing camera
The removal procedure of the camera is only for a touch display.
1 Follow the procedure in Before working inside your computer.
2 Remove the following:
a base cover
b battery
c WLAN card
d WWAN card
e display assembly
3 To remove the camera module:
a Peel o the two pieces of conductive tape covering the camera module [1].
NOTE
: The conductive tape is a separate part from the camera module that must be removed and then re-attached
when replacing the camera module.
b Flip the camera module [2].
c Disconnect the camera cable from the camera module [3].
d Lift and remove the camera module [4].
Removing and installing components
31