7 Remove the two (M2.0 x 5.0) screws that secure the USB Type-C bracket.
8 Flip the system board, peel o the tapes securing the bracket and remove the USB Type-C port from the system board.
NOTE
: When removing or reinstalling the USB Type-C bracket to the system board, technicians must place the system
board on an ESD mat to avoid damage.
Installing system board
1 Align the system board with the screw holders on the system.
2 Replace the M2.0 x 5.0 screws to secure the system board to the system.
3 Connect the speaker, LED board, coin cell battery, touchpad, and USH cables, and power connector, cables to the connectors on the
system board.
4 Connect the eDP cable to the connector on the system board.
Removing and installing components
37
To Next Page
Loading...
