6. Install the heat sink.
7. Install the system-board shield.
8. Install the back cover
9. Install the cable cover (optional).
10. Install the stand.
11. Follow the procedure in After working inside your computer.
Middle frame
Removing the middle frame
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
6. Remove the hard-drive.
7. Remove the wireless card.
8. Remove the bottom cover.
9. Remove the rear-I/O bracket.
10. Remove the speakers.
11. Remove the camera assembly.
12. Remove the system board.
13. Remove the power-button board.
14. Remove the microphones.
15. Remove the side-I/O board.
16. Remove the antenna module.
17. Remove the display panel.
About this task
The following image indicates the location of the middle frame and provides a visual representation of the removal procedure.
Removing and installing components
75
To Next Page
Loading...
