Figure 3. Articulate stand
Installing the stand
1. Place the computer on a clean, flat surface and align the stand, and then slide it on the back of the computer.
2. Press the stand down till it snaps in.
3. Follow the procedure in After working inside your computer.
Cable cover
Removing the cable cover
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. To remove the cable cover:
a. Remove the screw that secures the cable cover to the computer [1].
b. Push the release tabs to release the cable cover [2].
c. Lift the cable cover away from the computer [3].
Disassembly and reassembly
17
To Next Page
Loading...
