Solid State Drive
Removing the SSD card
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. stand
b. back cover
c. system board shield
3. To remove the SSD card:
a. Remove the screw that secures the SSD card to the computer [1].
NOTE: System is shipped with 2.5 inch SATA drive on the ODD drive port (Optional).
b. Lift the SSD card away from the connector [2].
Installing the SSD card
1. Insert the SSD card into the connector.
2. Tighten the screw to secure the SSD card to the system board.
3. Install the:
a. system board shield
b. back cover
c. stand
4. Follow the procedure in After working inside your computer.
Disassembly and reassembly
27
To Next Page
Loading...
