Installing the intrusion switch
1. Place the intrusion switch in the slot on the computer.
2. Tighten the screw to secure the intrusion switch to the chassis.
3. Route intrusion switch cable along the retention clips on the chassis.
4. Connect the intrusion switch cable to the connector on the system board.
5. Install:
a. VESA mount bracket
b. power supply unit
c. system board shield
d. speaker cover
e. cable cover
f. back cover
g. stand
6. Follow the procedures in After working inside your computer.
Processor
Removing the processor
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. stand
b. back cover
c. cable cover
d. speaker cover
e. speaker
f. VESA mount bracket
g. system board shield
h. SSD card
i. WLAN card
j. memory
k. heat sink
l. system fan
3. To remove the processor:
a. Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
b. Lift the lever upward and lift the processor shield [2].
Disassembly and reassembly
39
To Next Page
Loading...
