Table 5. SSD
● M.2 256 GB PCIe NVMe Solid State Drive Class 40
● M.2 256 GB PCIe NVMe Self Encrypting Solid State Drive
Class 40
● M.2 512 GB PCIe NVMe Solid State DriveClass 40
● M.2 1 TB PCIe NVMe Solid State Drive Class 40
Identifying the hard drive in Windows 10
1. Click inside the Cortana Search Box and type Control Panel and then click or press Enter on the keyboard, for the
appropriate search result
2. Click Control Panel, select Device Manager, and expand Disk drives.
The hard drive is listed under Disk drives.
Entering BIOS setup
1. Turn on or restart your laptop.
2. When the Dell logo appears, perform the following action to enter the BIOS setup program:
Tap F2 until the Entering BIOS setup message appears.
Hard drive is listed under the System Information under the General group.
3. On the left pane, select Settings > General > System Information.
The memory information is displayed on the right pane.
Memory configurations
The supported memory configurations for are as follows:
● 4GB DDR4, 2400MHz, (1 x 4GB)
● 8GB DDR4, 2400MHz, (1 x 8GB)
● 8GB DDR4, 2400MHz, (2 x 4GB)
● 16GB DDR4, 2400MHz, (2 x 8GB)
● 32GB DDR4, 2400MHz, (2 x 16GB)
NOTE: If this computer is purchased with Intel 6th Generation CPUs, the maximum MHz the computer can achieve is 2133.
Verifying system memory in Windows 10 and Windows 7
Windows 10
1. Click the Windows button and select All Settings > System.
2. Under System, click About.
Windows 7
1. Click Start → Control Panel → System
DDR4
DDR4 (double data rate fourth generation) memory is a higher-speed successor to the DDR2 and DDR3 technologies and
allows up to 512 GB in capacity, compared to the DDR3's maximum capacity of 128 GB per DIMM. DDR4 synchronous dynamic
Technology and components
55
To Next Page
Loading...
