Installing the hard drive assembly
1. Align the hard drive until the notches are aligned and the hard drive is secured in the bracket.
2. Place the hard drive onto the hard drive cage until the notches are aligned, then slide the Hard Drive assembly until the tab
locks into the cage.
3. Install the:
a. back cover
b. stand
4. Follow the procedure in After working inside your computer.
System board shield
Removing the system board shield
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. stand
b. back cover
3. To remove the system board shield:
a. Press the securing tab to release the system board shield from the slots on the computer [1].
b. Slide the system board shield away from the computer [2].
Installing the system board shield
1. Align and slide the system board shield until it snaps in.
2. Install the:
a. back cover
b. stand
Disassembly and reassembly
25
To Next Page
Loading...
