Dell OptiPlex GX50 - Page 192

190 Solving Problems
www.dell.com | support.dell.com
Bad command or
file name
The command for file
name you entered does not
exist or is not in the
pathname you specified.
Make sure you have spelled
the command correctly,
placed spaces in the proper
location, and used the
correct pathname.
Bad error-
correction code
(ECC) on disk read
The floppy drive or hard
drive controller detected
an uncorrectable read
error.
See "Floppy Drive
Problems" or "Hard Drive
Problems."
Controller has
failed
The hard drive or the
associated controller is
defective.
See "Floppy Drive
Problems" or "Hard Drive
Problems."
Data error The floppy or hard drive
cannot read the data.
Run the chkdsk utility in
the Microsoft Windows
operating system to check
the file structure of the
floppy or hard drive. See
your operating system
documentation for more
information.
If you are using another
operating system, run the
appropriate utility to check
the file structure of the
floppy or hard drive. See
your operating system
documentation.
Decreasing
available memory
One or more dual in-line
memory modules
(DIMMs) may be faulty or
improperly seated.
See "Computer Memory
Problems."
Diskette drive 0
seek failure
Diskette drive 1
seek failure
A cable may be loose, or
the computer
configuration information
may not match the
hardware configuration.
See "Floppy Drive
Problems" or "Hard Drive
Problems."
Diskette read
failure
A cable may be loose, or
the floppy may be faulty.
See "Floppy Drive
Problems" or "Hard Drive
Problems."
Message Cause Action