Dell OptiPlex GX50 - Expansion Card Cage (Small Desktop Computer Only); Removing the Expansion-Card Cage

74 Installing Upgrades
www.dell.com | support.dell.com
10 Close the computer cover, reconnect the computer and devices to
their electrical outlets, and turn them on.
NOTE: After you open and close the cover, the chassis intrusion detector
causes the following message to appear on the screen at the next computer
start-up:
ALERT! Cover was previously removed.
11
Reset the chassis intrusion detector by changing Chassis Intrusion to
Enabled or Enabled-Silent.
NOTE: If a setup password has been assigned by someone else, contact
your network administrator for information on resetting the chassis
intrusion detector.
12 If you removed a sound card, enter system setup, perform the
following steps:
a Enter system setup, select Integrated Devices, and change the
setting for Sound to On.
b Connect external audio devices to the audio connectors on the I/O
panel (see “I/O Panel—Small Form-Factor, Desktop, and Mini-
Tower Computers”).
13 If you removed an add-in network adapter, perform the following steps:
a Enter system setup, select Integrated Devices and change the
setting for Network Interface Card to On.
b Connect the network cable to the integrated connector on the I/O
panel (see “I/O Panel—Small Form-Factor, Desktop, and Mini-
Tower Computers”).
Expansion Card Cage (Small Desktop
Computer Only)
Removing the Expansion-Card Cage
CAUTION: Before you perform this procedure, see “Safety
Instructions.”
1
Open the computer cover.