46 │ Setting up the monitor
Connecting the monitor for DPBS for the first time
For the first time setting up the DPBS function:
1. Mak
e sure both the PC and the monitor are OFF.
2. Pr
ess the monitor power button to turn ON the monitor.
3. Connec
t the USB-C cable from the PC to the monitor.
4. Bo
th the monitor and PC will turn ON normally. If not, press either the monitor
power button or PC power button to boot up the system.
NOTE: Ensure that Dell Power Button Sync is set to On. See Dell Power
Button Sync.
To Next Page
Loading...
