72 │ Operating the monitor
NOTE: If you select Yes for either of the features mentioned above, the
message will not appear the next time you intend to change the
settings of these features. When you perform a factory reset, the
message will appear again.
When the monitor goes into Standby mode, the following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
You will see the following message before the Lo
ck function is activated:
NOTE: The message may be slightly different according to the selected
settings.
The OSD functions only in the normal operation mode. If you press the joystick
during th
e Standby mode, the following message will appear depending on the
selected input:
Activate the computer and the monitor to gain access to the OSD.
NOTE: The message may be slightly different according to the
connected input signal.
To Next Page
Loading...
