3. Install the keyboard.
4. Install the keyboard lattice.
5. Install the SIM card.
6. Install the primary memory.
7. Install the WWAN card.
8. Install the WLAN card.
9. Install the secondary memory.
10. Install the primary M.2 SSD.
11. Install the battery.
12. Install the base cover.
13. Install the secondary M.2 SSD.
14. Install the SD card.
15. Follow the procedure in after working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the heat-sink assembly.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the removal procedure.
Steps
1. Disconnect the power-adapter cable from the connector on the system board.
2. Peel and unroute the display cable from the route to access the power-adapter port slot.
3. Remove the (M2x3) screw that secures power-adapter port bracket.
4. Remove the power-adapter port bracket from the computer.
Removing and installing components
77
To Next Page
Loading...
