Figure 37. Installing the NDC
1. slot on the NDC 2. screw (2)
3. NDC 4. standoff (2)
5. connector 6. tab projections
Next steps
1. Install the PCIe mezzanine card.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing the NDC
After working inside your system
Hard drives or SSDs
Your system supports up to eight 2.5-inch SAS/SATA/PCIe SSDs or SAS/SATA hard drives and sixteen 1.8-
inch SAS SSDs. The hard drives or SSDs are supplied in special hot-swappable drive carriers that fit in the
drive bays and these drives connect to the system board through the hard-drive or SSD backplane board.
NOTE: Mixing of SSD/SAS/SATA hard drives is not supported.
107
To Next Page
Loading...
