4. Remove the cooling shroud retention bar.
NOTE: You must remove the cooling shroud retention bar to replace a faulty retention bar or
service other components inside the system.
5. Ensure that the memory module socket ejectors are in the locked position.
Steps
1. Lower the cooling shroud retention bar into the system until the screw holes on the cooling shroud
retention bar align with the screw holes on the chassis.
2. Install the screws to secure the cooling shroud retention bar to the system.
Figure 12. Installing the cooling shroud retention bar
1. screw (9) 2. cooling shroud retention bar
3. standoff (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing the sled
Removing the cooling shroud retention bar
After working inside your system
64
To Next Page
Loading...
