Figure 22. Installing the heat sink
1. retention screw (4) 2. heat sink
3. processor socket 4. retention screw slot (4)
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.
Related Links
Safety instructions
Before working inside your system
Installing a processor
After working inside your system
PCIe mezzanine card
Your system supports x16 Gen 3 PCIe mezzanine card, which provides an interface between the sled and
the PCIe switches on the FX2s enclosure.
NOTE: Ensure that the PCIe mezzanine card is set to Enabled in System Setup.
Removing a PCIe mezzanine card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
88
To Next Page
Loading...
