2. If you are removing a processor permanently, install the processor blank.
3. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing a processor
Installing a heat sink
Installing a processor blank and DIMM blank
After working inside your system
Installing a processor blank and DIMM blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove processor blank and DIMM blank when installing four processors or
service other components inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the heat sink and the processor.
4. Ensure that the memory module socket ejectors are in the open position.
Steps
1. Align the processor blank and DIMM blank with the memory module sockets on the system board.
2. Lower the processor blank and DIMM blank onto the memory module sockets such that the bottom
edges of the blank is firmly inserted into the memory module sockets.
3. Press the blank firmly until the memory module socket ejectors click into place.
78
To Next Page
Loading...
