6
Installing and removing sled components
This section provides information about installing and removing the sled components. For information
about installing and removing the enclosure components, see the enclosure Owner's Manual at
Dell.com/poweredgemanuals.
Safety instructions
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: Dell recommends that you always use an antistatic mat and antistatic wrist strap while
working on components inside the system.
CAUTION: Operating the system without the system cover can result in component damage
NOTE: To ensure proper operation and cooling, all bays in the system must be populated always
with either a system component or with a blank.
Before working inside your system
1. Turn off the sled using the CMC.
2. Remove the sled from the enclosure.
3. Install the I/O connector cover.
After working inside your system
Prerequisites
Follow the safety guidelines listed in safety instructions section.
Steps
1. Install the sled in the enclosure.
2. Turn on the sled.
Recommended tools
You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock.
The key is needed only if your system includes a bezel.
• Phillips #1 screwdriver
54
To Next Page
Loading...
