Figure 17. Installing a processor blank and DIMM blank
1. processor blank and DIMM blank 2. tab on the processor blank and DIMM
blank (4)
3. memory module socket (2) 4. memory module socket ejector (2)
Next steps
1. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a heat sink
Removing a processor
After working inside your system
Processors
Your system supports up to four Intel Xeon E5-4600 v4 or v3 product family processors.
CAUTION: If you are using a system with two processors, ensure that you use 74 mm wide heat
sinks for processors up to 105 W, 120 W or 135 W.
CAUTION: If you are using a 2.5-inch hard drive/SSD system with four processors, ensure that you
use 94 mm wide heat sinks for processors up to 105 W, 120 W or 135 W.
CAUTION: If you are using a 1.8-inch hard drive/SSD system with four processors, ensure that you
use only 74 mm wide heat sinks for processors up to 105 W, 120 W, or 135 W.
79
To Next Page
Loading...
