Dell PowerEdge FC830 - Recommended Tools; Removing and Installing a Blade; Removing the Blade

Figure 6. Removing the sled
1. sled handle 2. sled
3. FX2/FX2s enclosure
Related Links
Safety instructions
Installing the sled
Before working inside your system
After working inside your system
Installing the sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the I/O connectors, do not touch connectors or the connector
pins.
NOTE: Before installing the sleds, place the chassis in the location that you want.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. If you are installing a new sled, remove the plastic cover from the I/O connector(s) and save for
future use.
2. Press the release button on the sled handle to the open position.
3. Align the sled with the bay on the enclosure.
4. Slide the sled into the enclosure until the sled connectors are firmly engaged with the midplane
connectors.
56