Dell PowerEdge FC830 - Hard-Drive or SSD Backplane

2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 Phillips screwdriver ready.
4. Remove the hard-drive or SSD cage.
NOTE: You must remove the hard-drive or SSD cage to replace a faulty hard-drive or SSD cage
or service other components inside the system.
Steps
1. Align the slots on the sides of the hard-drive or SSD cage with the standoffs on the chassis.
2. Lower the hard-drive or SSD cage into the chassis until the slots on the hard-drive or SSD cage
engage with the standoffs on the chassis.
3. Slide the hard-drive or SSD cage into the chassis until it clicks into position.
4. Install the two screws to secure the hard-drive or SSD cage to the chassis.
Figure 54. Installing the hard-drive or SSD cage
1. standoff (4) 2. hard-drive or SSD cage
3. screw (2) 4. screw hole (2)
Next steps
1. Install the hard-drive or SSD backplane.
2. Install the harddrive or SSD.
3. Follow the procedure listed in the After working inside your system section.Follow the procedure
listed in the After working inside your system section.
121