Related Links
Safety instructions
Before working inside your system
Removing the cooling shroud
Installing the sled
After working inside your system
Cooling shroud retention bar
Removing the cooling shroud retention bar
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the cooling shroud retention bar to replace a faulty retention bar or
service other components inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 and #2 Phillips screwdrivers ready.
4. Remove the cooling shroud.
Steps
1. Remove the screws securing the cooling shroud retention bar to the system.
2. Hold the cooling shroud retention bar on the side of the chassis and lift it away from the system.
62
To Next Page
Loading...
