1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
NOTE: You must remove the cooling shroud to replace a faulty cooling shroud or service other
components inside the system.
Steps
1. Align the slots on the side of the cooling shroud with the standoffs on the cooling shroud retention
bar.
2. Lower the cooling shroud into the system until the slots on the cooling shroud engage with the
standoffs on the cooling shroud retention bar.
3. Slide the cooling shroud to the lock position.
4. Tighten the retention screw to secure the cooling shroud on the cooling shroud retention bar.
Figure 10. Installing the cooling shroud
1. slot (2) 2. cooling shroud
3. retention screw 4. standoff on the cooling shroud
retention bar (2)
Next steps
Follow the procedure listed in the After working inside your system section.
61
To Next Page
Loading...
