Dell PowerEdge FC830 - Page 126

Figure 56. Installing a 2.5-inch (x8) SATA hard-drive or SSD backplane
1. alignment pin (2) 2. power cable
3. retention screw on the top of the hard-
drive or SSD backplane (4)
4. hard-drive or SSD backplane
5. hard-drive or SSD backplane cable
connector
6. hard-drive or SSD backplane cable
7. retention screw on the bottom of the
hard-drive or SSD backplane (4)
8. screw holes
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 2.5 inch (x8) SATA hard-drive or SSD backplane
After working inside your system
126