Dell PowerEdge FC830 - Page 128

Figure 57. Removing a 2.5-inch (x8) SAS hard-drive or SSD backplane
1. alignment pin (2) 2. power cable
3. retention screw on the top of the hard-
drive or SSD backplane (4)
4. hard-drive or SSD backplane
5. hard-drive or SSD backplane cable
connector
6. hard-drive or SSD backplane cable
7. retention screw on the bottom of the
hard-drive or SSD backplane (4)
8. screw holes on the hard-drive or SSD
cage (6)
Next steps
1. Install the hard-drive or SSD backplane.
Related Links
Safety instructions
Before working inside your system
Installing a 2.5-inch (x8) SAS hard-drive or SSD backplane
After working inside your system
128