Figure 62. Installing a 2.5-inch (x6) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane
1. slot on the SATA hard-drive or SSD
backplane cable
2. standoff on the chassis
3. SATA hard-drive or SSD backplane cable 4. retention clipNext
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 2.5-inch (x6) SATA hard drive or SSD and 2.5-inch (x2) PCIe SSD backplane
After working inside your system
Removing a 1.8-inch (x16) SAS SSD backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the SSD backplane to replace a faulty SSD backplane or service other
components inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
136
To Next Page
Loading...
