Figure 63. Removing a 1.8-inch (x16) SAS SSD backplane
1. power cable 2. alignment pin
3. retention screw on the top of the
backplane (3)
4. backplane cable (2)
5. backplane cable connector that connects
to the connector on the expander card
6. backplane
7. guide pin (3) 8. backplane cable connector that
connects to the connector on the
system board
9. SSD cage
Next steps
1. Install the SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing a 1.8-inch (x16) SAS SSD backplane
After working inside your system
138
To Next Page
Loading...
