3. Keep the #2 Phillips screwdriver ready.
4. Remove the PCIe mezzanine card support bracket.
NOTE: You must remove the PCIe mezzanine card support bracket to replace a faulty system board.
Steps
1. Orient the PCIe mezzanine card support bracket toward the back of the system.
2. Align the tabs on the PCIe mezzanine card support bracket with the slots on the system and slide it
until the tabs on the support bracket engage with the slots on the system.
3. Install the screw to secure the PCIe mezzanine card support bracket on the system board.
Figure 26. Installing the PCIe mezzanine card support bracket
1. screw 2. PCIe mezzanine card support bracket
3. tab on the bracket (2) 4. slot on the system (2)
5. system board
Next steps
1. Install the PCIe mezzanine card.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing the PCIe mezzanine card support bracket
Installing a PCIe mezzanine card
After working inside your system
93
To Next Page
Loading...
