Dell PowerEdge R210 - Page 23

About Your System 25
Maximum rank
count exceeded.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 79.
Memory address
line failure at
address, read
value expecting
value.
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory" on page 116.
Memory double
word logic
failure at
address, read
value expecting
value.
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory" on page 116.
Memory
Initialization
Warning: Memory
size may be
reduced.
Invalid memory
configuration. The system
will run but with less
memory than is physically
available.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 79.
Memory odd/even
logic failure at
address, read
value expecting
value.
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory" on page 116.
Memory
write/read
failure at
address, read
value expecting
value.
Faulty or improperly
installed memory modules.
See "Troubleshooting System
Memory" on page 116.
Message Causes Corrective Actions
book.book Page 25 Wednesday, August 12, 2009 4:51 PM