About Your System 29
Sector not
found.
Seek error.
Seek operation
failed.
Faulty hard drive or USB
medium or device.
Replace the USB medium or
device. Ensure that the USB
is properly connected. See
"Troubleshooting a USB
Device" on page 110 or
"Troubleshooting a Hard
Drive" on page 120 for the
appropriate drive(s) installed
in your system.
Shutdown
failure.
General system error. See "Getting Help" on
page 133.
The amount of
system memory
has changed.
Memory has been added or
removed or a memory
module may be faulty.
If memory has been added or
removed, this message is
informative and can be
ignored. If memory has not
been added or removed,
check the SEL to determine
if single-bit or multi-bit
errors were detected and
replace the faulty memory
module. See
"Troubleshooting System
Memory" on page 116.
Message Causes Corrective Actions
book.book Page 29 Wednesday, August 12, 2009 4:51 PM
To Next Page
Loading...
