Dell PowerEdge R6625 - Removing the BOSS-N1 Module

Figure 138. Installing the BOSS filler
Align the BOSS card filler with the BOSS N1 controller card module bay and push it into the bay until it clicks into place.
Figure 139. Installing the BOSS module filler
Removing the BOSS-N1 module
The procedure to remove is the BOSS-N1 module with 2 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
158
Installing and removing system components