Figure 45. Installing the drive backplane cover
Next steps
1. Follow the procedure listed in After working inside your system..
Control panel
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the drive backplane cover.
4. If installed, Remove the air shroud.
Steps
1. Disconnect the right control panel cable from the connector on the system board.
2. Press and pull the latch to slide the cable out of the clip.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel to the system.
4. Holding the cable, slide the right control panel out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 79
To Next Page
Loading...
