NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 68. Installing the drive backplane
3. Route the cables properly through the cable guide and connect the cables to the connector on the system board. Tighten
the captive screw on the cable guiding latch.
Next steps
1. Install all the drives.
2. If removed, Install the air shroud.
3. Install the drive backplane cover.
4. Follow the procedure listed in After working inside your system.
Cable routing
Cable routing refers to the organization and management of cables in a computer system or network. This involves arranging
the cables in a neat and organized manner to improve airflow, reduce clutter, and prevent interference with other components.
Effective cable routing can enhance the overall performance and reliability of a computer system, as well as improve its
appearance.
Figure 69. 4 x 3.5-inch SAS/SATA
98
Installing and removing system components
To Next Page
Loading...
