NIC port specifications
The PowerEdge R6625 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on
the LAN on Motherboard (LOM) and integrated on the Open Compute Project (OCP) cards.
Table 18. NIC port specification for the system
Feature Specifications
LOM card (optional) 1 GbE x 2
OCP card (OCP 3.0) (optional) 1 GbE x 4, 10 GbE x 2, 10 GbE x 4, 25 GbE x 2, 25 GbE x 4
NOTE: The system allows either LOM card or an OCP card or both to be installed in the system.
NOTE: On the system board, the supported OCP PCIe width is x8; when x16 PCIe width is ins talled, it is downgraded to x8.
Serial connector specifications
The PowerEdge R6625 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R6625 system supports two DB-15 VGA port one each on the front and back panel.
Video specifications
The PowerEdge R6625 system supports integrated Matrox G200 graphics controller with 16 MB of video frame buffer.
Table 19. Supported video resolution options
Resolution Refresh rate (Hz) Color depth (bits)
1024 x 768 60 8, 16, 32
1280 x 800 60 8, 16, 32
1280 x 1024 60 8, 16, 32
1360 x 768 60 8, 16, 32
1440 x 900 60 8, 16, 32
1600 x 900 60 8, 16, 32
1600 x 1200 60 8, 16, 32
1680 x 1050 60 8, 16, 32
1920 x 1080 60 8, 16, 32
1920 x 1200 60 8, 16, 32
Technical specifications 31
To Next Page
Loading...
