Dell PowerEdge R6625 - Initial system setup and configuration

Figure 38. Install system into the extended rails
5. Pull blue slide release lock tabs forward or backward on both rails, and slide the system into the rack.
Figure 39. Slide system into the rack
Initial system setup and configuration
This section describes the tasks for initial setup and configuration of the Dell system. The section also provides general steps to
set up the system and the reference guides for detailed information.
Setting up the system
Perform the following steps to set up the system:
Steps
1. Unpack the system.
2. Install the system into the rack. For more information, see the rail installation and cable management accessory guides
relevant to your rail and cable management solution at www.dell.com/poweredgemanuals.
3. Connect the peripherals to the system and the system to the electrical outlet.
Installation
47