Dell PowerEdge T30 - NIC Port; Video Specification; Environmental Specifications

Table 16. USB specifications
Front panel Back panel Internal
Two 4-pin USB 2.0-compliant Two 4-pin USB 2.0-compliant Two 4-pin USB 2.0-compliant
Two 4-pin USB 3.0-compliant Four 4-pin USB 3.0-compliant -
NIC port
The PowerEdge T30 system supports a Network Interface Controller (NIC) port on the back panel, which is available in 10/100/1000
Mbps NIC configurations.
Video specification
The PowerEdge T30 system supports:
• Intel® HD Graphics P530 for Intel Xeon E3-1200 v5 processor
• Intel® HD Graphics 510 for Intel Pentium processor
• Intel® HD Graphics 530 for Intel Core i3 series processor
Environmental specifications
NOTE
: For additional information about environmental measurements for specific system configurations, see Dell.com/
environmental_datasheets.
Table 17. Environmental specifications
Type Condition Temperature or Specification
Temperature
Maximum Temperature Gradient (Operating and Storage) 20 °C/h (36 °F/h)
Storage Temperature Limits –40 °C to 65 °C (–40 °F to 149 °F)
Continuous operation (for altitude less than 950 m or 3117 ft) 5 °C to 35 °C (41 °F to 95 °F) with no direct sunlight on
the equipment.
Relative Humidity
Storage 5% to 95% RH with 33 °C (91 °F) maximum dew point.
Atmosphere must be non-condensing at all times.
Operating 10% to 80% Relative Humidity with 29 °C (84.2 °F)
maximum dew point.
Maximum Vibration
Operating 0.26 G
rms
at 5 Hz to 350 Hz (operating orientation).
Storage 1.37 G
rms
at 5 Hz to 200 Hz for 15 minutes (all six sides
tested).
Maximum Shock
Operating Six consecutively executed shock pulses in the positive and
negative x, y, and z axes of 6 G for up to 11 ms.
20 Technical specifications