Figure 7. Removing the system cover
Next steps
1 Install the system cover.
2 Place the system upright on its feet on a flat and stable surface.
3 Reconnect the peripherals and connect the system to the electrical outlet.
4 Turn the system on, including any attached peripherals.
Related links
Safety instructions
Installing the system cover
Installing the system cover
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Ensure that all internal cables are connected and placed out of the way, and no tools or extra parts are left inside the system.
Steps
1 Align the tabs at the bottom of the system cover on the slots on the chassis.
2 Push the system cover until it locks into place.
Installing and removing system components
41
To Next Page
Loading...
