Figure 8. Installing the system cover
Next steps
1 Place the system upright on its feet on a flat and stable surface.
2 Reconnect the peripherals and connect the system to the electrical outlet.
3 Turn on the system, including any attached peripherals.
Related links
Safety instructions
Bezel
The bezel is attached to the front side of the server and prevents accidents while removing the hard drive or when pressing the reset or
power button. The front bezel can also be locked for additional security.
Removing the bezel
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Release the four retention clips that secure the bezel to the chassis. The clips are located at the edge of the bezel.
2 Pull the bezel away from the system.
42
Installing and removing system components
To Next Page
Loading...
