Dell PowerEdge T430 - Removing a 3.5-Inch Hard Drive Adapter from a 3.5-Inch Hot Swappable Hard Drive Carrier

Figure 35. Installing a 2.5-inch hot swappable hard drive into a 3.5-inch hard drive adapter
1. 3.5-inch hard drive adapter 2. screw (2)
3. 2.5-inch hard drive
Next steps
Install the 3.5-inch adapter into the 3.5-inch hot swappable hard drive carrier.
Related links
Safety instructions
Removing a 2.5-inch hot swappable hard drive from a 3.5-inch hard drive adapter
Removing a 3.5-inch hard drive adapter from a 3.5-inch hot swappable hard
drive carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the 3.5-inch hot swappable hard drive carrier from the system.
Steps
1. Remove the screws from the rails on the 3.5-inch hot swappable hard drive carrier.
2. Lift the 3.5-inch hard drive adapter out of the 3.5-inch hot swappable hard drive carrier.
Next steps
Remove the 2.5-inch hot swappable hard drive from a 3.5-inch hard drive adapter.
106