Figure 87. Removing and installing the PSU divider
1. PSU divider 2. tabs (4)
3. screw
Next steps
1. Install the redundant PSUs or PSU blank as applicable.
2. Reconnect the system to its electrical outlet and power on the system, including any attached
peripherals.
Non-redundant AC/cabled power supply unit
Your system supports a non-redundant 450 W AC power supply unit (PSU).
NOTE: Non-redundant PSU is supported in systems with cabled hard drives and systems with an x8
backplane.
NOTE: When selecting or upgrading your system configuration, verify the system power
consumption with the Dell Energy Smart Solution Advisor at Dell.com/ESSA to ensure optimum
power utilization.
180
To Next Page
Loading...
