Figure 15. Installing the front bezel
1. bezel key 2. bezel
3. system
Related links
Removing the optional front bezel
System feet
The system feet provide stability to the system in the tower mode.
Removing the system feet
Prerequisites
NOTE: It is recommended that you remove the system feet only when you are converting the
system from the tower mode to the rack mode, or when you are replacing the system feet with the
wheel assembly.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Turn the system feet inward.
4. Place the system on its side on a flat and stable surface.
Steps
Remove the screws that secure the system feet to the base of the tower.
82
To Next Page
Loading...
