Dell PowerEdge T430 - After Working Inside Your System; Recommended Tools; Front Bezel (Optional); Removing the Optional Front Bezel

After working inside your system
Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Install the system cover.
2. Place the system upright on its feet on a flat, stable surface.
3. If applicable, install the system into the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
4. If removed, install the optional front bezel.
5. Reconnect the peripherals and connect the system to the electrical outlet.
6. Turn on the system, including any attached peripherals.
Related links
Installing the system cover
Installing the optional front bezel
Recommended tools
You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock.
This is needed only if your system includes a bezel.
• Phillips #2 screwdriver
• Plastic scribe
• Wrist grounding strap
Front bezel (optional)
The front bezel is attached to the front side of the server and prevents accidents while removing the hard
drive or when pressing the reset or power button. The front bezel can also be locked for additional
security.
Removing the optional front bezel
Steps
1. Unlock the bezel by using the bezel keys.
NOTE: There are two bezel keys attached to the back of the bezel.
2. Press the release latch at the top of the bezel.
3. Pull the top end of the bezel away from the system.
4. Unhook the bezel tabs from the slots at the bottom of the system board, and pull the bezel away
from the system.
80