System top cover
Do not remove the system top cover unless you are converting the system from tower to rack mode.
Removing the system top cover
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
4. Remove the system cover.
Steps
1. Remove the screws that secure the top cover to the chassis.
2. Slide the cover toward the back of the system and lift it from the system.
Figure 114. Removing the system top cover
1. system top cover 2. screw (3)
213
To Next Page
Loading...
