Dell PowerEdge T430 - Expansion Cards; Expansion Card Installation Guidelines

Related links
Safety instructions
Before working inside your system
Removing the expansion card holder
After working inside your system
Expansion cards
Expansion card installation guidelines
Table 35. PCI Express Generation 3 expansion cards supported
PCIe Slot Processor Connection Height Length Link Width Slot Width
1 Platform Controller
Hub
Full Height Half Length x4 x8
2 Platform Controller
Hub
Full Height Half Length x1 x1
3 Processor 1 Full Height Full Length x16 x16
4 Processor 1 Full Height Full Length x16 x16
5 Processor 2 Full Height Half Length x8 x8
6 Processor 2 Full Height Half Length x8 x8
NOTE: Only slots 3, 4, 5, and 6 support Generation 3 PCIe expansion cards.
NOTE: Do not use slots 5 and 6 for single processor configuration (CPU1).
NOTE: When your system is installed with a double-width GPU card in slot 3, you cannot install an
expansion card in slot 2.
NOTE: When your system is installed with a double-width GPU card in slot 4, you cannot install an
expansion card in slot 3.
NOTE: The expansion cards are not hot-swappable.
The following table provides a guide for installing expansion cards to ensure proper cooling and
mechanical fit. The expansion cards with the highest priority must be installed first using the slot priority
indicated. All other expansion cards must be installed following the card priority and slot priority order.
Table 36. Expansion card installation order
Card Priority Card Type Slot Priority Maximum Allowed
1 GPU 4 1
GPU (AMD W7000) 3, 4 2
2 RAID 3, 4 2
RAID (H830) 3, 4, 5, 6 4
3 10 Gb NICs 3, 4, 5, 6, 1 5
149