Figure 112. Installing the screws on the system board
1. screws (9)
Next steps
1. Install the Trusted Platform Module (TPM). For information on how to install TPM, see Installing the
Trusted Platform Module section. For information on TPM, see the Trusted platform module section.
2. Replace the following:
a. processors(s) and heat sink(s)
b. internal USB key (if required)
c. internal dual SD module
d. cooling shroud
e. internal cooling fan
f. expansion cards
g. expansion card holder
h. iDRAC ports card
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured
using the cable securing bracket.
209
To Next Page
Loading...
